minileiste AL16X5 end profile, 16x6x2000mm

The width of the connection joint should be between 5 and 12 mm depending on the used profile system. The thickness of the flooring must also be taken into account. Type X5 systems can be used with a minimum floor covering thickness of 5 mm.

The dimensions for the profile cuts are taken from the wall surfaces. Miter cuts for inside and outside corners are taken into account.

The profiles are cut to length. The miter cut for inside or outside corners is made in one step. The profile is securely positioned in the cutting aid. This prevents the profile from jamming during the cutting process.

The mounting clips are pushed into the profile on the front. Attention: Two opposite shoulders are worked into the profile, between which the mounting clips are easily guided.

Insert mounting clips every 30 cm in the end strip.
ONLY FOR FLOATING FLOORS: Before installing the profiles, apply some flexible installation adhesive or silicone into the end joint to fix the profile securely.

The end profile with the inserted mounting clips is now brought into the mounting position on the wall surface. With the assembly aid, the assembly clips are carefully spreaded out by using the assembly aid to apply the assembly clips towards the wall.

As soon as the clamping process is completed, the end profile is pressed down and the assembly aid is removed. Now the tensioning and assembly process is repeated until all assembly clips on an end profile are tensioned and countersunk. For any corrections the end profile can be removed from the connection joint at any time.

The end profile is installed. After a brief inspection, the next section can be assembled.