minileiste UL25X2 transition profile for adhesive vinyl, 25x3x2000mm

The width of the connection joint should be between 2 and 10 mm. The thickness of the flooring must also be taken into account. Type X2 systems can be used with a minimum floor covering thickness of 2 mm.

The dimensions for the profile cuts are taken from the floor covering.
Any mitre cuts are taken into account.

The profiles are cut to length. The profile is securely positioned in the cutting aid. This prevents the profile from jamming during the cutting process.

The individual profiles are „tried on“ WITHOUT adhesive BEFORE installation. If everything fits, the profiles are removed again and gluing begins.

The individual adhesive strips are peeled off the adhesive sheet (observe the peel-off tab) and glued to the floor covering on one side towards the long side, flush with the edge of the transition joint. The floor covering must be dry and free of dust and grease. Clean before installation if necessary. Ideal installation temperature from +15°C to +30°C.

Stick the adhesive strips onto the floor covering every 30 cm according to point 5. Before installing the transition profiles, pull the yellow wax foil of the adhesive strips upwards at the tab.

Now the transition profile can simply be glued onto the adhesive strips. Correct positioning is important because after the first adhesive strip the skirting board can no longer be moved parallel to the transition joint.

The transition profile is installed. After a brief inspection, the next section can be assembled.